The Freedom Fighter Tactical 1/2 Inch Diameter Steel Tactical Charging Handle for Benelli M4 Shotgun
WE ARE SOLD OUT OF THIS HANDLE AND WE DO NOT HAVE AN EXPECTED DELIVERY DATE STATUS. ONCE WE DO WE WILL POST IT HERE. UNTIL THEN ALL CALLS AND EMAILS YOU'RE GOING TO HEAR EXACTLY WHAT YOU JUST READ ABOVE. WE ARE WORKING ON THEM AND WE THANK YOU FOR YOUR PATIENCE.
👉🏻 1. WE ONLY SHIP ON SUNDAY
👉🏻 2. WE USE USPS PRIORITY WITH A SIGNATURE REQUIREMENT (NO EXCEPTIONS ARE MADE)
👉🏻 3. WE DO NOT SHIP OUTSIDE OF THE USA (NO EXCEPTIONS ARE MADE - THAT MEANS WE DO NOT SHIP TO CANADA)
Replacing the factory bolt handle on the Benelli M4 is a must for any serious M4 enthusiast. FFT has had great success with both the 1/2 and 3/4 inch charging handles.
FFT's steel tactical charging handle is manufactured with pre-heated high grade steel, and heat treated again to a Rockwell C 32 with a tensile strength of 132,000 P.S.I. It has an amazingly low weight of 17 grams. It is finished off with a zinc phosphate finish that beautifully matches the finish on the Benelli M4.
The FFT steel charging handle has a beautiful rugged knurling around the outside of the handle, with three smooth rings that enhance the grip. While charging handles do not help the Benelli enthusiast with 922(r) compliance, all handles are stamped ñMade in USA.î
The FFT steel charging handles for the Benelli M4 are properly made to fit for the Benelli M4 shotgun ONLY.
Finally, the charging handles made by FFT for the Benelli M4 are not the same as the ñspinnerî models that are oftentimes offered in the marketplace for the Benelli M4. Instead, FFTs charging handles properly lock into place just as the original factory Benelli M4 bolt handle.
Our charging handles go great with any of the steel magazine tubes, the FFT 922(r) compliant tactical forend, and any the FFT 922(r) compliant followers. Of course, all of FFTs parts may be mixed and matched to your liking.
For Benelli M4 (models 11707, 11717, and 1014)