The Freedom Fighter Tactical 3/4 Inch Diameter Steel Tactical Charging Handle for Benelli M4 Shotgun

Replacing the factory bolt handle on the Benelli M4 is a must for any serious M4 enthusiast. The 3/4 inch steel charging handle is FFT’s original charging handle.

FFT's steel tactical charging handle is manufactured with pre-heated high grade steel, and heat treated again to a Rockwell C 32 with a tensile strength of 132,000 P.S.I. It is finished off with a zinc phosphate finish that beautifully matches the finish on the Benelli M4.

The 3/4 inch steel charging handle has a beautiful rugged knurling around the outside of the handle, with three smooth rings that enhance the grip. While charging handles do not help the Benelli enthusiast with 922(r) compliance, the 3/4 inch handles are stamped “Made in USA.”

The 3/4 inch steel handle is properly made to fit for the Benelli M4 shotgun - and is not compatible with the Benelli M1, M2, or M3 shotguns.

Finally, the 3/4 inch steel charging handles made by FFT are not the same as the “spinner” models that are oftentimes offered in the marketplace for the Benelli M4. Instead, FFT’s charging handles properly lock into place just as the original factory Benelli M4 bolt handle.

The 3/4 inch steel charging handle goes great with any of the steel magazine tubes, the FFT 922(r) compliant tactical forend, and any the FFT 922(r) compliant followers. Of course, all of FFT’s parts may be mixed and matched to your liking.

For additional questions and answers about 922(r) compliance, please review FFT’s page addressing this law.

For Benelli M4 (models 11707, 11717, and 1014)